Z Microsystems ZX Station - Manual (Page 9)

Document# 27-0007UM Issued 11/00 Rev. 1.0
Tighten the slide mount
to the cabinet frame on
the back of the cabinet
frame.
Make sure to hold the
slide mounts hard
against the rack rail.
9
On the slide rails, using
a Phillips screwdriver,
loosen the screws on
each side.
An adjustable wrench or
box wrench may be
used to hold the nut on
the other side of the
slide rail.
On the rear of the
RETMA Rail, use three
panhead Phillips
screws with washers
per side to loosely
secure the right and left
rear slider mount to the
RETMA Rail.
DO NOT tighten these
screws fully at this
time.
On the front of the
RETMA Rail, use three
pancakehead Phillips
screws per side to
secure the right and left
slider rails.
DO NOT tighten these
screws to allow for
adjustment of the ZX
Station within the
cabinet frame.
Use the proper screws
(from left to right).
Pancakehead Phillips
screw to install the front
of the slider rail and top
of lid.
Panhead Phillips
screw and washer to
install the back of the
slider rail.
Ovalhead Phillips
screw, stainless steel
and nylon receptacle
washers to install the
front panel.
INSTALL THE SLIDES IN CABINET FRAME
Install Slides