Z Microsystems ZX Station - Manual (Page 8)

Document# 27-0007UM Issued 11/00 Rev. 1.0
SLIDE REMOVAL
Lay the ZX Station on a
workbench.
The slide rail will reach
a stop about half way
out.
This is a safety stop to
prevent the ZX Station
from sliding out too far
while mounted to the
rack.
Simultaneously press
in the safety catches on
each slide rail and
remove the slide rails
all the way off the back
of the ZX Station.
The slides should now
be separated from the
ZX Station.
8
Install Slides