Uplink connections, Subscriber lines, Adsl2+ inverse mul tiplexer – Zhone Technologies 4000E User Manual

Page 13: Uplink module, Fa n pwr lnk act dplx pwr

Advertising
background image

Uplink Connections

IPD4-A2-ZZ40-20

4000E IP Broadband Loop Carrier Installation Instructions

13

7 Turn your power source(s) on. The PWR (power) LED on both the

interface module and management module faceplates will illuminate solid

green to indicate the modules are receiving power.

Uplink Connections

No configuration is necessary for Uplink Interface Modules (UIMs) or Media
Interface Modules (MIMs) installed on the management module in your
4000E to operate at default settings. However, if you wish to run your uplink
connections at settings other than the UIM or MIM defaults, configure the
UIM or MIM prior to making a connection.

For further connection and configuration information, refer to the installation
instructions of your particular UIM or MIM model.

Subscriber Lines

No configuration is necessary for the interface module(s) installed in your
4000E to operate at default settings. However, if you wish to run your
subscriber connections at settings other than the factory defaults, configure
the interface module(s) prior to connection. Refer to the installation
instructions for your particular interface module(s).

The 4000E chassis supports ADSL, IDSL, SDSL and T1/E1 technologies.
Ensure that the subscriber lines you are connecting correspond with the
technology of the interface module(s) installed in your 4000E.

05-17837

Power LED

Management

Module

Interface

Module

MUL

TIPLEXER UPLINK MODULE

FA

N

PWR

Lnk

Act

Dplx

PWR

ADSL2+ INVERSE

MUL

TIPLEXER

1

2

RX

TX

LK

05-17838

IP DSL Access Multiple

xer

4000E

U1

4

3

2

1

A

C

C

E

S

S

Uplink Module

MUM

MUL

TIPLEXER UPLINK MODULE

FA

N

PWR

Lnk

Act

Dplx

PWR

ADSL2+ INVERSE

MUL

TIPLEXER

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

RX

TX

LK

TIM

Advertising