Installing your management module, Installing a management module, Caution – Zhone Technologies 4000E User Manual

Page 8

Advertising
background image

8

4000E IP Broadband Loop Carrier Installation Instructions

IPD4-A2-ZZ40-20

Installing Your Management Module

A management module provides the functional control for the 4000E BLC;
the 4000E cannot function without one. There are several different models
available. Contact your sales representative.

Installing a Management Module

An uplink module provides the upstream network connection for the 4000E
BLC; a management module cannot function without one. Depending on the
management module model that you plan to install in your 4000E, you will
need either a Media Interface Module (MIM) or an Uplink Interface Module
(UIM). Only one uplink module is required for operational purposes.
However, two uplink modules may be installed, one in each port of the
management module, if redundancy is desired. Refer to your management
module or uplink module installation instructions for further information.

CAUTION

If a slot cover is removed from a management module uplink port, it must

be replaced with an uplink module. DO NOT OPERATE A 4000E WITH

A MANAGEMENT MODULE THAT HAS AN OPEN UPLINK PORT.

1 Identify the appropriate slot for installation.

The 4000E is a five slot chassis: slots 1–4 are reserved for interface

modules and Slot U1 is reserved for a management module. The 4000E is

shipped from the factory with slots 1 and U1 open and ready for module

installation.

2 Align the management module with the slot module guides. With the

management module printed circuit board (PCB) facing up and the

management module model name on the right side of the module

faceplate (facing towards you), align the left and right edges of the PCB

with the U1 slot module guides on the 4000E.

05-17828

IP DSL Access Multiple

xer

4000E

U1

4

3

2

1

A

C

C

E

S

S

Management Module

Slot

Advertising