Zhone Technologies 4000E - Manual (Page 16)

16 4000E IP Broadband Loop Carrier Installation Instructions IPD4-A2-ZZ40-20
The LK (Link) LED for each port being connected with a remote modem will
illuminate solid or flashing green to indicate a connection has been
established. Link up time between interface modules and remote modems can
vary from one to five minutes depending on the quality, gauge and distance of
the copper cable pair(s) being used. Refer to individual interface module user
guides for specific information such as connector pinouts, parameter
configurations and distance capabilities.
Securing the Connecting Cables
Position all connecting cables such that they will not become a tripping
hazard or pull loose from the chassis; secure with cable ties or hook-and-loop
fastener straps.
Configuration and Management
Although no configuration is necessary to run subscriber lines at the default
settings, all 4000E parameter settings are software selectable via Command
Line Interface (CLI), Simple Network Management Protocol (SNMP), and/or
the Network Management System (NMS). 4000E management capabilities
depend upon the management module model installed in your chassis. Once
the management module has been initialized, the interface modules installed
in your 4000E may also be configured as desired. Refer to the following for
further information:
05-17845
PWR
ADSL2+ INVERSE
MUL
TIPLEXER
1 2 3 4 5 6 7
RX
TX
LK
Table 1: User Documentation
Document Contents
Management module
installation instructions
(model-specific)
z
module installation
port pinouts
parameter defaults
parameter configuration options
management system capabilities
Uplink module
installation instructions
(model-specific)
z
module installation
port pinouts
parameter defaults
parameter configuration options