3M M150 - Manual (Page 15)

3M Touch Systems Proprietary Information
CHAPTER 2
Setting Up Your M150 FPD Monitor
This chapter describes how to set up and integrate your 3M Touch Systems
M150 FPD monitor into a touch application. You need to complete the
following tasks:
• Unpack the components
• Connect the video, touch screen, and power cables
• Power on the monitor and test your setup
• Install the touch screen software
• Calibrate the touch screen
System Requirements
The M150 flat-panel touch monitor requires a personal computer (PC).
This touch monitor will not work with Macintosh computers.
The requirements for your PC are as follows:
• Your PC must have an available RS-232 serial communication (COM) port.
You connect the touch screen to this port.
• Your PC must have a video card and video driver already installed for the
monitor. If you need to install a video card or a video driver, refer to your
computer documentation for instructions.
• Your PC must have a unique interrupt request (IRQ) available to the touch
screen COM port. The touch screen cannot share an IRQ with another device.
• If the only serial port available on your PC has 25 pins, you will need a 9-pin to
25-pin adapter.