3M M150 - Manual (Page 23)

Chapter 2 Setting Up Your M150 FPD Monitor
3M Touch Systems Proprietary Information
23
Cable Management System
Figure 8 Removing the Cable Management Cover
Once you have connected your M150 FPD monitor to your computer, you
should take advantage of the cable management system designed into the
base of the M150 FPD monitor as shown above.
In order to properly route all cables through the cable management system,
the cover on the base unit must be removed. To remove this cover:
1. Push in and lift up on each of the two tabs located on the left and right sides of
the cover. This action will release the cover tabs from the base.
2. Slide the cover back towards you to remove.
Testing the M150 FPD
Note: The M150 FPD has a power status light located on the front of the bezel.
After connection, turn on the power switch located at the bottom of the
front bezel. Before you test your touch monitor, make sure all cables are
connected properly and routed through the cable management system. Be
sure to tighten all cable screws.