3M M150 - Manual (Page 30)

30 M150 FPD Monitor Installation Guide
3M Touch Systems Proprietary Information
Position
You can use the Position option to center the image on the display
manually. Use the ◄/left and ►/right arrow buttons to scroll through the
position menu.
• H-Position is used to adjust the horizontal image position manually.
• V-Position is used to adjust the vertical image position manually.
Image
Use the ◄/left and ►/right arrow buttons to scroll through the image menu.
Phase: If the phase of your monitor is not fine-tuned, you may observe
unstable horizontal noise lines and cross-talk stretching from the edge of
small windows on your display.
If you change your display to Windows shut down mode, this noise will be
more visible, and easier to eliminate. Click on the "Start" button at the
bottom right side, and then click Shut Down. This will bring you to the
Windows shutdown mode. After finishing phase adjustment, click on the
"Cancel” to return to your original Windows display.
Clock: If the clock setting of your image is not fine-tuned, you may observe
periodic vertical bars of video noise on your image. These bars of noise are
usually adjusted out when an Auto Configuration is performed. If the bars
of noise are still present, this setting can be adjusted manually.