Edimax Technology EW-7228APn - Manual (Page 61)

61
Note: To reset the IP address back to its
default value of 192.168.2.1, press and hold
the WPS/Reset button on the access point
for 10 seconds. Be aware that doing so
restores all settings and passwords back to
factory defaults.
Click “APPLY” to save changes. The following message will appear:
Click “CONTINUE” to save the changes but not apply them yet. This allows you
to make further changes in the browser-based management interface, before
applying them all at once.
Click “APPLY” to restart the device and implement any changes. The device will
restart itself.
III-7-3. DHCP Server
The access point can be configured to act as a DHCP server for your network.
By default DHCP is disabled.
Note: This option will be unavailable unless
you enable this function by selecting
“Enabled” from the drop down menu
labeled “DHCP Server”, under the heading
“Management IP” as detailed above
Enter the appropriate information as shown below.