Petzl SEQUOIA SWING - Manual (Page 4)

4 C69SFA SEQUOIA SWING C695050D (080610)
5
5
Harness preparation and pre-adjustment
Harness preparation and pre-adjustment
Clic!
MAX
5B. Adjust the height of the
attachment bridge (position
of the gated rings)
You can adjust the height of the
attachment bridge according to your
body morphology and your specifi c
usage (3 positions possible). This
adjustment allows you to be closer
to or further from the attachment
bridge. See drawing.
GATED RINGS
- Open the gated rings by unscrewing the screw with the n° 25 male Torx driver supplied
with the product.
- Close the ring and don’t forget the spacer.
- It is absolutely necessary to put a drop of thread-lock
on the screw.
- Tighten the screw until the red indicator is no longer
visible; continue tightening to a torque of 3 Nm.
Verify that the three straps are correctly positioned in the
gated rings (straps should not be twisted or intertwined).
WARNING, do not use the SEQUOIA SWING without the
ATTACHMENT BRIDGE.
- Reposition the straps.
Slide the two seat width adjustment extensions and verify the rapid adjustment system
is securely engaged in the holes (see drawings). The extensions must be locked.
Do not exceed the maximum value indicated on the underside of the seat.
Do a suspension test to verify comfort. The straps (9) should not be too tight;
if they are, increase the seat width.
3,0 Nm
thread-lock