FIAT Grande Punto Actual - Manual (Page 20)

19
SAFETY
ST
AR
TING
AND DRIVING
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SER
VICE
AND CARE
TECHNICAL
SPECIFICA
TIONS
INDEX
CONTROLS AND DEVICES
Setting the speed limit (SPEEd)
With this function, it is possible to set the
car speed limit (km/h or mph). When this
limit is exceeded, the driver is immediately
alerted (see section “Warning lights and
messages”).
To set the desired speed limit, proceed as
follows:
– briefly press MENU ESC – the mes-
sage (SPEEd) and the previously set unit
(km/h) or (mph) will appear on the display;
– press + or – to activate (On) or deac-
tivate (Off) the speed limit;
– if the function is on, press + or – to se-
lect the required speed limit and then
press MENU ESC to confirm;
NB The speed may be set in the range
from 30 to 200 km/h, or from 20 to
125 mph according to the previously cho-
sen unit (see “Setting the distance unit
(Unit)” below). The setting will in-
crease/decrease by five units each time
+/– is pressed. Hold down +/– to in-
crease/decrease the setting rapidly. When
you get close to the desired value, finish
the setting with single presses.
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
To cancel the setting, proceed as follows:
– briefly press MENU ESC: (On) will
flash on the display;
– press –: (Off) will flash on the display;
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
Setting the clock (Hour)
With this function, it is possible to set the
time.
To do so, proceed as follows:
– briefly press MENU ESC – the “hours”
will flash on the display;
– press + or – to set the value;
– briefly press MENU ESC – the “min-
utes” will flash on the display;
– press + or – to set the value;
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
Adjusting the buzzer volume
(BUZZ)
This function is used to adjust the volume
of the buzzer that sounds in the event
of failure/warning indications and when
the MENU ESC, + and – buttons are
pressed.
To set the desired volume, proceed as
follows:
– briefly press MENU ESC – the display
will show the wording (bUZZ);
– press + or – to select the required vol-
ume (adjustable over 8 levels).
– briefly press MENU ESC to return to
the menu screen or hold the button down
to return to the standard screen without
saving.
001-032 ACTUAL 2ed EN.qxd 30-04-2010 12:33 Pagina 19