FIAT Grande Punto Actual - Manual (Page 85)

84
SAFETY
ST
AR
TING
AND DRIVING
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SER
VICE
AND CARE
TECHNICAL
SPECIFICA
TIONS
INDEX
CONTROLS AND DEVICES
CAR INACTIVITY fig. 103
(with Start&Stop system with
dummy pole)
(for versions/markets where provided)
In case of vehicle inactivity conditions, pay
special attention to the disconnection of
the battery power supply. The procedure
must be made by disconnecting the quick
release negative terminal A-fig. 103 from
the dummy negative pole B, as the battery
negative pole C has a sensor D for bat-
tery condition monitoring that must nev-
er be disconnected (unless the battery is
replaced).
CAR INACTIVITY fig. 104
(with Start&Stop system without
dummy pole)
(for versions/markets where provided)
In case of car inactivity, special attention
must be paid due to the disconnection of
the battery power supply. Proceed as fol-
lows: detach the connector A-fig. 104 (by
pressing button B) from sensor C for
monitoring the battery status installed on
the battery negative pole D. This sensor
should never be disconnected from the
pole except if the battery is replaced.
EMERGENCY STARTING
(with Start&Stop system with
dummy pole)
(for versions/markets where provided)
In case of vehicle jump starting, never
connect the negative cable (–) of the
auxiliary battery to the negative pole
B-fig. 105 of the vehicle battery, rather
to the dummy pole A or to an en-
gine/gearbox earth point.
When replacing the battery,
always go to a Fiat Dealer-
ship. Replace the battery using a new
one of the same type (HEAVY DUTY)
and having the same specifications.
WARNING
fig. 103 F0M0514m fig. 104 F0M0516m fig. 105 F0M0517m
072-092 ACTUAL 2ed EN 30-04-2010 12:37 Pagina 84