Garmin GPSMAP 2110 - Manual (Page 12)

 GPSMAP 2106/2110 Owner’s Manual
g
ettIng
s
tArted
> t
urnIng on the
gPsMAP 2106/2110
Turning on the GPSMAP 2106/2110
Before you turn on the GPSMAP 2106/2110, make sure the unit and GPS 17
antenna are correctly installed on your vessel according to the instructions in the
GPSMAP 2106/2110 & GPS 17 Installation Instructions.
The first time you turn on the GPSMAP 2106/2110, the GPS 17 receiver
must collect satellite data and determine its current location. To ensure proper
initialization, the GPSMAP 2106/2110 is shipped from the factory in AutoLocate
mode.
To turn on the GPSMAP 2106/2110:
1. Press and hold the POWER key until the unit turns on.
2. When I Agree is highlighted on the Warning Page, press ENTER to open
the Map Page.
NOTE: The first time you turn on the unit, you are asked if you want to start
the retail demonstration. Select No, and press ENTER.
To turn off the GPSMAP 2106/2110:
Press and hold the POWER key until the unit turns off.
Adjusting the Backlight
You can adjust the screen backlighting on the GPSMAP 2106/2110 from any page
by using the POWER/BACKlIGhT key.
To adjust the backlight level:
1. Press and release the POWER/BACKLIGHT key.
2. Press up on the ROCKER to increase the brightness, or press down to
decrease.
TIP: After you open the Backlight adjustment window, press the
POWER/BACKlIGhT key repeatedly to cycle through the three
backlight settings: Highest, Middle, and Lowest.
Highest Middle Lowest
3. Press ENTER or QUIT to close the Backlight adjustment window.