American Magnetics 12200PS DC Power Supply (CE-Marked) - Manual (Page 19)

INSTALLATION OPERATING MANUAL
2-4 Release 1.0 (98/07)
2.3.2 Periodic Cleaning
No routine servicing of the power supply is required except for periodic cleaning. Whenever a unit is removed
from operation, clean metal surfaces with naphtha or an equivalent solvent and the front panel with a weak
solution of soap and water. Use low-pressure compressed air to blow dust from in and around components on
the printed circuit boards.
2.3.3 Packaging for Shipping or Storage
Follow these instructions to prepare the unit for shipping or storage.
1. When returning the unit or sending it to the service center, attach a tag to the unit stating its model
number, available from the front panel label, and its serial number, available from the rear panel label.
Give the date of purchase and an invoice number, if you have it, as well as a brief description of the
problem.
2. For storage or shipping, repack the power supply in its original container. If the original container is
not available, seal the unit in a plastic bag and then pack it in a 200 lb. (90 kg) test, corrugated
cardboard carton large enough to allow 2" (5 cm) of cushioning material to surround the unit. Use a
material such as foam slabs or chips.
3. Label the carton as shown in Figure 2.3-3.
4. If shipping, mark the address of the service center and your return address on the carton.
5. If storing, stack no more than eight cartons high. Check the storage temperature range and storage
altitude specification in Section 1.3.6.
POWER SUPPLY
Model Number: _________________
Serial Number: _________________
FRAGILE - ELECTRONIC EQUIPMENT
Figure 2.3-3 Shipping or Storage Carton Label