American Magnetics 12200PS DC Power Supply (CE-Marked) User Manual
Page 27
INSTALLATION
OPERATING MANUAL
2-12
Release 1.0 (98/07)
2.7.2
Making Load Connections (continued)
7.5V to 100V Models
The 7.5V to 100V models come with a bus bar cover and strain relief. See Figure 2.7-2.
To detach the bus bar cover before connecting load wires:
1.
Undo #6-32 x 5/16" Phillips pan head screws, #6 x 0.288" lock washers, and #6 x 5/16" flat washers (3
places) from bus bar top cover.
2.
Pull upward on output bus bar top cover to remove it.
3.
Undo #6-32 x 1/4" Keps nuts and #6 x 5/16" flat washers from chassis-mounted PEM studs (3 places)
to remove output bus bar chassis cover.
Figure 2.7-2 Output Strain Relief and Bus Bar Cover
Strain Relief
Top Cover
Chassis Cover
Wire Clamp
and Screw
Keps Nut and
Flat Washer
(3 places)
Screw,
Lock Washer,
and Flat Washer
(3 places)