None key, Configuring a none key, Line keys and softkeys – AASTRA 6757i User Guide EN User Manual
Page 120
Line Keys and Softkeys
113
41-001385-00 Rev 01 – 06.2013
None Key
You can set a softkey, or expansion module key to force a blank entry on the IP phone display for a specific key. You do
this by setting the key to "None". The keys are added in order (from key1 to key20) after any hard-coded keys have been
added. If a particular key is not defined, it is ignored. For more information about key behavior, see
on
.
Configuring a None Key
Use the following procedure to configure a None key on the 6757i IP Phone. The procedure shows the softkey screen as
an example.
Note:
If you enable global DND on the phone, the incoming multicast RTP session is dropped.
Aastra Web UI
1.
Click on Operation->Softkeys and XML.
or
Click on Operation->Expansion Module <N>.
Softkeys
2.
Select from “Key 1” through “Key 10” on the Top keys.
or
Select from "Key 1" through "Key 20" on the Bottom keys.
3.
In the "Type" field, select None.
Expansion Module Keys
4.
Select from “Key 1” through “Key 36” (M670i)
or
Select from “Key 1” through “Key 60” (M675i)
5.
In the "Type" field, select None.
6.
Click Save Settings.