Empty key, Configuring an empty key, Line keys and softkeys – AASTRA 6757i User Guide EN User Manual
Page 121
Line Keys and Softkeys
41-001385-00 Rev 01 – 06.2013
114
Empty Key
You can set a softkey to force a blank entry on the IP phone display for a specific key. You do this by setting the softkey to
"empty". The keys are added in order (from key 1 to key 20) after any hard-coded keys have been added. If a particular key
is not defined, it is ignored.
Configuring an Empty Key
Use the following procedure to configure an Empty softkey on the 6757i phone.
Aastra Web UI
1.
Click on Operation->Softkeys and XML.
or
Click on Operation->Expansion Module <N>.
Softkeys
2.
Select from “Key 1” through “Key 10” on the Top keys.
or
Select from "Key 1" through "Key 20" on the Bottom keys.
3.
In the "Type" field, select Empty.
4.
(Bottom Softkeys) In the state fields, check (enable) or uncheck (disable) the states you want to apply to this softkey.
Expansion Module Keys
5.
Select from “Key 1” through “Key 36” (M670i)
or
Select from “Key 1” through “Key 60” (M675i)
6.
In the "Type" field, select Empty.
7.
Click Save Settings.