Hotchkis 22815 Audi Allroad Sport Sway Bar Set - Manual (Page 3)

8/ Apply supplied grease to inner-channeled portion of both rear bushings.
(approx. quarter tube per bushing; picture on next page) Then install the
bushings to the bar at approx. the stock locations. Position the bar in the stock
location then install the brackets over the bushings.
9/
Re-install the end link bolts (using the supplied 10mm washers in
between the nut and the end link head) and nuts and leave loose. Secure the
bushing brackets, using the supplied 8mm washers in between the nuts and
the slots of the bushing brackets. Tighten the four bracket bolts, then tighten
the end link bolts.
*Adjustability Note: To adjust between the two holes, you must unbolt the
bushing bracket bolts and pull the bar towards the rear so that the end link
bolts clear the shock bodies. The hole at the bar’s end is the softer while
the second hole from the end is the harder setting.
10/
Finally, re-attach exhaust hangers to the metal tabs on both sides.
YOU’RE DONE WITH THE REAR, NOW THE FRONT!!
1/ Drive the vehicle onto a 4-post lift or floor ramps. T HE CAR NEEDS TO BE AT
NORMAL RIDE HEIGHT FOR PROPER INSTALLATION . You cannot have the suspension
hanging while installing this bar!
2/
Once vehicle is raised, use a standard screwdriver and Torx socket and
remove the aero-pan fasteners. Then remove the pan entirely exposing the anti-
roll bar.