Hotchkis 22815 Audi Allroad Sport Sway Bar Set - Manual (Page 4)

3/ Take a moment and observe the stock front bar and the way in
which it is mounted.
4/
Remove the lower end link bolts and nuts (16mm wrench) to the bar and
save only the bolts for re-installation. Remove the four bracket nuts and save.
(13mm wrench or socket) Remove the stock bar.
5/
Apply grease to each inner-channeled portion of the two new front
bushings and attach to HSport bar against the outside of the washers on the bar.
Slip the new brackets over the bushings.
6/
Lift the bar up to the vehicle. The two smaller Hotchkis stickers at the
bar’s ends should be right-side-up. As you lift the bar up to the mounting points,
you must place one mounting plate per side between the bushing and the
mounting point.
This relocates the bushing out of the stock bushing pocket.