Hotchkis 80113 1967-1972 Dodge A-Body Total Vehicle System - Manual (Page 28)

Reposition the bar back onto the k-frame so the mounting bracket is sitting flush with the k-frame. A jack does a
good job of holding the bar in place for you. You will now weld the bracket to the k-frame. The best way to start
is to tack weld a couple of spots around the bracket. Once the brackets are secure, unbolt the D-shaped bushing
bracket and end links to get the bar out of the way. Finish welding a bead as shown in the picture below. Also
weld up the holes creating a rosette weld.
5F Grease sway bar bushings with supplied urethane specific grease, re-install sway bar, and end links, and
completely tighten all hardware.