Hotchkis 81001 Chassis, Max Convertible Set, 67-69 Camaro-Firebird F-Body - Manual (Page 10)

4007/4008/4009 67-69 Camaro/Firebird
Hotchkis Performance LLC.
4
3. Mock up Subframe Connector
Preparation is needed before any welding can begin. First, decide whether you will be
welding in the connector to the front subframe or bolting it in.
Install the subframe connector using the provided 5/8” bolt and the thick washer. Use
a transmission jack to hold the rear end of the connector up. Fully tighten the 5/8” bolt
to see where the connector will position itself. Make sure the rear end of the connector
is butted up against the rear frame rails. This mock-up should simulate how the
connector will be mounted on the vehicle.
Bolt-In: Mark the front subframe to indicate where your bolt holes will be.