Install the bushing brackets, Drill holes for the end link brackets – Hotchkis 22105 "Tri 5 Chevy Front Sport Sway Bar" User Manual
Page 5
3F
Install the Bushing Brackets
With the holes drilled out and reinforcement plates in position, you are now ready to install the
bushing brackets. Apply the supplied silicon grease on the inside of each bushing. Install the
bushings onto the sway bar. Place the bushing bracket onto the bushing. Hold the bar up to
the chassis and slide the reinforcement plate studs into the bushing bracket holes. Install the
supplied nuts to the studs. You may fully tighten these nuts.
4F
Drill Holes for the End Link Brackets
Install the end links as shown in the picture. Position the sway bar so that the end link
bracket is located on the lower control arm properly. Important note: Make sure the sway
bar is centered with the car. A good way to measure this is to look at the gap between the
sway bar ends and the frame on each side.