Hotchkis 22835F BMW E36 Front Sway Bar - Manual (Page 8)

11R
Install Bushing Bracket Hardware
Install the bushing bracket hardware included in your kit. The bushing brackets have slots in
them so you will notice that the bar can be shifted up or down slightly. Shift the bar up and
tighten the bar at this position. If the bracket is positioned too low, it may come in contact
with the exhaust pipes.
12R
Securing End Links to Sway Bar
Before you attach your end links to the sway bar, we must first adjust the height for the end
links. Since your ride height may be different than other E36’s, end link adjustment will be
mandatory. Rotate your sway bar into position so that the holes on the end match the hole in
the end link; note the gap between the bar & the axle and the bar & the lower control arm.
Thread the end link body in or out to adjust the length of the end link. Try to make the gaps
above and below the sway bar to be the same.