Hotchkis 2255F Front Sway Bar Set, Dodge B-Body 1966-1969 - Manual (Page 2)

5. Our main objective is to find out where you will be welding on the Hotchkis bushing
retainer brackets. In order to do that you will have to mock up where the bar is going to be
positioned. We will first attach the bar to the end links. Raise the Hotchkis front sway bar
into position on the car. Install the end links that connect the lower control arm to the
sway bar ends. See picture. Snugly tighten, but do not make too tight.
6. Once the end links are attached, install the bushings and brackets to the bar. Make sure to
apply the included silicon grease. You will also need to install the new Hotchkis bushing
retainer bracket onto the bushing bracket as shown in the picture. Attach the driver and
passenger side D-Shaped bushing & bracket and position them as outboard as possible.