Hotchkis 22827 Audi RS6 Sport Sway Bar Set - Manual (Page 5)

8) Apply supplied grease to inner surface of both rear bushings. Then install the bushings to the bar
at approx. the stock locations. Install the brackets over the bushings with the grease fittings
pointed down.
9) Reverse the procedure and position Hotchkis bar in the stock location with the “H-Sport” sticker
facing rearward, right side up.
10)
Re-install the end link with the provided nuts & bolts and leave loose.
Adjustability Note: To adjust between the two holes, you must unbolt the bushing bracket
bolts and pull the bar towards the rear so that the end link bolts clear the shock bodies. The
hole at the bar’s end is the normal setting, while the second hole from the end is the stiffer
setting.