Hotchkis 22827 Audi RS6 Sport Sway Bar Set User Manual
Page 8
6/
Lift the bar up to the vehicle. The two smaller HSport stickers at the bar’s ends should be
right-side-up. As you lift the bar up to the mounting points, you must place one mounting plate
per side between the bushing and the mounting point.
This relocates the bushing out of the
stock bushing pocket.
7/
Re-install the bracket nuts and tighten. Use a small portion of blue thread-locker on the
end-link bolts, re-install and tighten well. **Note** If vehicle is raised using jack stands or other,
the bar end and the end link may not align properly. Lower vehicle so that front suspension is
not at full droop and ends will align. Be sure to thread end link bolt by hand at first to prevent
cross threading
.
8/
Re-install the aero pan, however, a small portion of both sides of the pan may need to be filed
down for the bar ends to clear. Make this modification if you have difficulty attaching the black plastic
fasteners within either wheel well. Some A6s have different aero pans than others.
Enjoy your new tubular Sway Bar kit from Hotchkis! If you need assistance with the install or have
any other questions, go to the ‘instructions’ button on our site or call us at the number below.
Thank you for choosing the best anti-roll bar kit available for your RS6!
Hotchkis Performance
562.907.7757
12035 Burke St. Suite 13
Santa Fe Springs, CA 90670