Hotchkis 2273 Sway Bars, Set, 67-70 GM B-Body, Sport User Manual
Page 3
5)
The end of the bar on the driver’s side should now be free. Pull the end of the bar towards the
front bumper and rotate as necessary to remove the bar from the vehicle. Do not
straighten the
front wheels at this time. They should still be turned slightly towards the driver’s side of the
vehicle.
6)
With the stock bar now removed, insert the Hotchkis bar by reversing the previous directions.
Make sure the center “hoop” of the bar points down when installing the bar. If the bar is put in
backwards, then the bar will contact the balance pulley on the front of the motor. Start by
inserting the end of the bar into the round hole on the passenger side of the vehicle frame
NOTE
:
To avoid damage to the powder coat surface of the bar, cover the edges of the holes in the
frame. Use a towel, duct tape or similar product to accomplish this.