Hotchkis 2273 Sway Bars, Set, 67-70 GM B-Body, Sport User Manual
Page 9
7)
Snug down the hardware connecting the end links and brackets to the bar. Do not fully tighten
the hardware at this stage. You should still be able to rotate the end links without difficulty.
8)
Rotate the bar upwards, so that the brackets are resting against the frame. Once the brackets
are in place use a scribe or some other tool to mark the center of each hole for drilling.
Drill out the holes for the brackets to 7/16” diameter. To accurately determine the location of the holes
the end links must not be loose enough to move left or right. Make certain the axle is at its normal
driving height for an accurate fit.
9)
Once the holes are drilled, drop the remaining 3/8” bolts from hardware kit #1735 in through
the top of the frame with the bolts hanging down for the brackets to attach to.