Banks Power Dodge Trucks: (Diesel ’94 - 98 5.9L Cummins) Power Systems- PowerPack, Stinger-Plus & Stinger systems - Manual (Page 14)

14
Install the banks ottomind fuel calibration
cam in the same position as the stock
fuel cam plate, with zero clearance between
the front edge of the calibration cam and the
guide template. Replace the two screws to retain
the calibration cam and tighten. Remove the
installation guide template and keep it with your
stock fuel cam plate for future use.
once installation is complete, replace the
cam-plate cover on the pump, swing the
fuel shutdown solenoid bracket into place and
thread the two lower cover screws into the pump
until finger-tight. Re-install one original screw in
the upper rear bolt-hole. This is a temporary-use
screw, to be replaced by the new break-off screw,
provided, when fuel calibration is complete.
place the cover in its exact original position, as
indicated by the scribe lines on the cover and
pump body. maintaining its position, tighten the
cover bolts and rear fuel-shutdown bracket bolt
that was previously loosened.
after engine performance has been checked,
replace the temporary-use phillips-head screw
with the new break-off screw provided. CaUTIoN:
failure to install the new break-off screw when
fuel calibration and performance have been
verified can invalidate your emissions warranty.
Reconnect the rubber hose and plastic tube
to the “tee” fitting on the air flow valve
cover, tighten the hose clamp and tube nut.
for Stinger and Stinger-plus installation, proceed
to Step 69.
TWIN RAM MANIFOLD INSTALLATION
Clean any remaining gasket residue from
the cast iron surface of the cylinder head.
Take care to keep the gasket material from
entering the cylinder head cavity. Remove
any rags placed in the head cavity at this time
to allow for the installation of the TwinRam
manifold components.
Install the air temperature sensor in the
large threaded hole in the Twin Ram base
plate. place the new gasket provided over the bolt
pattern in the cylinder head and place the base
plate in position. See figure 12. apply a drop of
Loctite to the threads of four metric socket-head
capscrews provided and install into the recessed
holes in the base plate. Install ten factory fasteners
58.
55.
54.
57.
56.
figure 12
p.N. 96384 V.3.0