Banks Power Dodge Trucks: (Diesel ’94 - 98 5.9L Cummins) Power Systems- PowerPack, Stinger-Plus & Stinger systems User Manual
Page 9
9
fIGURE 7
head with clean rags to keep foreign material out
while working.
It is necessary to remove the two heater
elements from the intake manifold cover
casting for reinstallation with the TwinRam
manifold. first carefully grind the staked threads
from the bottom of the studs protruding into the
underside of the cover so that the nuts can be
removed. In some cases the nuts can simply be
unscrewed over the staked threads. These studs
and nuts will be reused. Remove all the nuts and
washers that retain the heater elements and
remove the elements from the manifold cover.
Remove the studs, spacers and mica insulating
washers and sleeves from the casting and set all
the pieces aside for later use. Remove the air
temperature sensor from the cover and set aside
for later use.
for Twin-Ram manifold installation only, proceed
to step 57.
OTTOMIND INSTALLATION
To realize power gains made available by the
increased airflow through the banks components,
the fuel delivery of the injection pump must also
be increased. This installation procedure will
provide the additional fuel flow required.
The injection pump is located on the
upper left side of the engine, and can be
identified by the row of six injector pressure tube
connections on top of the pump body.Locate
the cam plate cover on the injection pump. See
figure 7. The cover is just to the rear of the area
where the six injector pressure tubes connect to
the pump body, and is retained by four screws.
Clean any dirt, grease, or foreign material from the
cam plate cover, especially in the area where the
cam plate cover flange contacts the main pump
body, to prevent contaminants from entering into
the pump upon disassembly.
Use a sharp scribe to scribe a line in the injector
pump body along the outside edge of the cam plate
cover where the cover attaches to the pump (along
the upper edge of the cover, on the side facing
46.
47.
p.N. 96384 V.3.0