Banks Power Dodge Trucks: (Diesel ’94 - 98 5.9L Cummins) Power Systems- PowerPack, Stinger-Plus & Stinger systems - Manual (Page 15)

15
figure 13
finger tight in the remaining positions. Note the
location of two slightly longer factory fasteners
for mounting the fuel filter bracket. also note the
location of the new injection line bracket provided.
on non-EGR models, use one of the metric cap
screws provided (see figure 12). on EGR models,
reinstall vacuum regulator solenoid bracket.
Remove the two line clamp assemblies
from the injector feed lines that are bolted
to brackets. Remove the plastic caps from the
fuel pump and the injector nozzles. Reinstall the
injector line assembly on the engine using the new
bracket provided as shown in figure 11. Do not
tighten lines at this time. Torque all fourteen of
the base plate bolts to 18 lb-ft. working from the
center, outward.
59.
p.N. 96384 V.3.0