Banks Power Dodge Trucks: (Diesel ’94 - 98 5.9L Cummins) Power Systems- PowerPack, Stinger-Plus & Stinger systems User Manual
Page 11
Note the position of the cam plate attached
to the pump body by two screws. mark a
scribe line in the pump body at the forward edge
of the cam plate where it contacts the pump
body. See figure 10. This mark can be used as a
reference should the original cam plate need to
be reinstalled.
place the installation guide template
provided over the stock fuel cam plate. This
template will provide the position reference for
the banks ottomind calibration cam. Note: The
guide template will only fit one way. If it appears
to be misaligned or does not seem to fit, flip the
plate over and try again.
Using two of the short cam cover screws
previously removed, loosely attach the guide
template to the fuel pump body. Slide the guide
template toward the rear of the engine so that
there is zero clearance between the front edge of
the fuel cam plate and the guide template. Hand
tighten the two screws so that the guide template
DoES NoT move during the remainder of the banks
ottomind installation.
Loosen and remove the two screws holding
the fuel cam plate in place. keep these for
reuse. Remove the stock fuel cam plate. keep this
piece in a safe location in case it is needed for
future work on your vehicle.
53.
52.
51.
50.
11
fIGURE 10
p.N. 96384 V.3.0