Wiring – Banks Power Universal Car & Truck: (Gas or Diesel ’50 - 14 Universal) Water-Methanol: Straight-Shot and Double Shot, Vehicle specific applications User Manual
Page 15
97651 v.1.0
15
: Take care when
installing the mounting panel as to
not damage anything critical with
fasteners.
2.
Install the mounting panel using sup-
plied fasteners.
3.
Install injection controller in mounting
panel and secure using controller bracket.
Wiring
: Route and secure wir-
ing where it will not interfere with
moving or hot engine components
(along OEM wiring where possible).
Avoid sharp edges that may damage
wiring.
1.
Using provided system schematics,
find connectors for injection controller on
the pump harness (P/N 62831) and signal
harness (P/N 62832). Carefully feed these
connectors and boost reference hose (P/N
94445) through firewall grommet (usually
located underneath dash) to injection con-
troller. See Figure 34
2.
Connect both 8-pin connectors to
controller where appropriate. Connect
2-pin connector for EGT thermocouple,
if equipped. See Figure 35
3.
Secure boost reference hose to refer-
ence port barb on back of injection con-
troller using the 3/32” hose (P/N 94118) as
an adapter between the boost reference
hose and the reference port barb. See
Figure 36
4.
Route appropriate connectors of sig-
nal harness to respective Water-Methanol
injection components and fasten connec-
tors. Secure wiring with tie wraps.
5.
Route appropriate connectors of pump
harness to respective Water-Methanol
injection components and fasten connec-
tors. Secure wiring with tie wraps.
Figure 33
Figure 34
Figure 35
Figure 36
Figure 37