Injection pump – Banks Power Universal Car & Truck: (Gas or Diesel ’50 - 14 Universal) Water-Methanol: Straight-Shot and Double Shot, Vehicle specific applications User Manual
Page 6
6
97651 v.1.0
3.
Thread 90-degree male Push-Lock fit-
ting (P/N 45121) into threaded bung of
tank. Tighten 2-3 turns past hand tight.
Do not over tighten. Add enough water in
reservoir to check for leaks around fitting.
See Figure 5
4.
Drain water and use provided mount-
ing straps, bolts (P/N 91120), nuts (P/N
91110), and washers (P/N 91103) to mount
tank where desired. See Figure 6
Injection Pump
: Injection pump (P/N
45030 or 45031) can be mounted in any
orientation, but is flow directional.
The head unit is labeled with an
arrow to show flow direction. Take
care while determining the mount-
ing location in your vehicle.
See Figure 7
1.
Determine where pump will be mount-
ed so that it will not interfere with mov-
ing or hot engine components and will
avoid spray and debris from tires. Use
pump bracket as a template to mark
where bracket will be mounted. Ensure
that the desired location will not interfere
with vehicle operation and that drilling at
this location for mounting will be safe.
See Figure 8
: Take care while
drilling and know what is behind
the piece you are drilling through.
Note the location of the fuel tank,
fuel lines, wiring, etc.
2.
Use a center punch to mark the hole
locations and keep the drill bit from wan-
dering. Use a 1/4” drill bit to drill the
necessary holes where marked to mount
pump bracket. Deburr sharp edges.
: Use eye and ear
protection while drilling.
Figure 6
Figure 7
Figure 9
Figure 8
Figure 5