Banks Power Universal Car & Truck: (Gas or Diesel ’50 - 14 Universal) Water-Methanol: Straight-Shot and Double Shot, Vehicle specific applications - Manual (Page 8)

8
97651 v.1.0
3.
Thread straight Push-Lock fittings
(P/N 45120) into both ports of sole-
noid. Tighten two turns past hand tight.
See Figure 14
4.
Use provided bolts (P/N 91118), nuts
(P/N 91110), and washers (P/N 91102) to
mount solenoid bracket in your vehicle.
See Figure 15
5.
Use provided screws (P/N 91725)
and washers (P/N 91826) to mount
the solenoid onto solenoid bracket.
See Figure 16 and 17
Injection Nozzle(s)
: If your vehicle is
equipped with a late model Banks
Monster Ram, you do not have to
drill and tap your intake duct as
the Monster Ram has the proper
threaded ports.
1.
Injection nozzle(s) (P/N 45081-45090)
should be mounted in your air intake
duct, post-intercooler (if equipped) and
approximately 6” before throttle body (if
equipped) where possible. When engine
is cool, mark the location on your air
intake duct where injection nozzle(s) will
be installed so that they will not interfere
with moving or hot engine components.
See Figure 19-22
: If installing multiple
injection nozzles, we recommend
separating the injection nozzles by
at least 3” to avoid crossing spray
patterns. See Figure 18
2.
Remove air intake duct and cover
engine and intake tube with clean rags to
avoid getting debris into your engine.
: Intake duct can
be drilled and threaded while on
engine ONLY if you can ensure that
no debris will enter engine or intake
tube. We highly recommend remov-
ing intake duct from vehicle.
3.
Use a center punch to mark the hole
locations and keep the drill bit from wan-
dering. Use a 11/32” drill bit to drill a hole
at marked location(s). Drill perpendicu-
lar to the intake duct surface to ensure
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18
Optional
Primary Stage
Solenoid
Shown