Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Exhaust Brake '03-early 04 - Manual (Page 10)

10 |
9 7 0 5 3 v . 8 . 0
on vehicles with automatic
transmissions).
14.
route the Banks Brake
Gray and BLuE wires behind
the battery box on the driver side
along the fender with the factory
harness. they should come around
between the battery and the fuse
box toward the engine block. See
Figure 5. shorten the BLuE wire
by 10” and install a male spade
connector.
For APP sensors mounted on the
engine proceed to step 15.
For APP sensor located beneath
the fuse box above the tire
proceed to step 16.
15.
remove and keep the three
(3) bolts that mount the accelerator
pedal position (aPP) sensor to the
engine. turn the aPP sensor to its
side and locate the yELLOW wire
on the electrical connector. Install
a t-tap and plug the BLuE Banks
Brake wire into it. see Figure 6.
re-install the aPP sensor with the
three (3) bolts. Skip to Step 31.
16.
route the BLuE wire toward
the bottom of the fuse box. The
accelerator pedal position (aPP)
sensor is located beneath the fuse
box above the tire. Locate the
WhItE wire with Dark GrEEN
stripe on the wire loom going into
the aPP sensor. Install a t-tap
into this wire and plug the BLuE
Banks wire into it. see Figure 7.
Note: On some early 2003
vehicles, the WhItE wire on the
aPP sensor shall be used. Skip to
Step 31.
For 2003 Vehicles
with manual
transmissions
17.
Find the WhItE wire with
OraNGE stripe in the wire loom
entering the large black electrical
connector on the driver side. this
is the same connector removed in
Step 4. Open the convolute and
remove the electrical wire tape
around the wire loom. Install a
t-tap on the WhItE wire with
OraNGE stripe. Plug the Banks
Brake OraNGE wire into it.
see Figure 4.
WarNING: there are a few
WhItE wires with different color
stripes in close proximity and may
easily be mistaken for the right
lead. Be sure to pick the correct
wires as described.
18.
In the same wire loom, locate
the LIGht GrEEN wire with
BLaCk stripe and install a t-tap.
Plug the Banks Brake BLaCk
wire to it.
19.
In the same wire loom, find
the yELLOW wire with rED
stripe. Cut the wire and crimp a
female spade connector on one
end of the cut wires and a male
spade connector on the other
end. (It does not matter which
connector goes on which wire.)
Connect the two Banks BrOWN
wires from the harness to these
spade connectors.
20.
route the Banks Brake
Gray and BLuE wires behind
the battery box on the driver’s side
along the fender with the factory
harness. they should come around
between the battery and the fuse
box toward the engine block. See
Figure 5. Install a spade on the
BLuE wire.
For APP sensor mounted on the
engine proceed to step 22.
Figure 6