Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Exhaust Brake '03-early 04 - Manual (Page 17)

9 7 0 5 3 v 8 . 0
| 17
16.
57.
Install the compressor panel
onto the sheet metal bracket.
tighten the
1 ⁄
2
” and 5 ⁄
16
” bolts to
securely mount the compressor
panel in place.
58.
Locate the GrEEN and the
BLaCk terminal pair on Banks
brake wire harness that was
previously installed. Plug the
GrEEN wire to the GrEEN wire
on the compressor pump. Plug the
BLaCk wire to the BLaCk wire
on the compressor pump.
59.
Locate the rED wire with
ring terminal on the compressor.
route this wire to the positive
battery terminal on the driver side.
remove the nut from the bus bar
stud and place the ring terminal
over the stud. re-install the nut on
the bus bar stud.
60.
Locate the fuse on the
compressor wire harness. use
cable tie to securely mount it
on the wire harness as shown
in Figure 17. assemble the
compressor pump air filter to the
straight push lock fitting using the
provided coupling.
61.
route the 4-ft air hose
toward the positive battery
terminal following the brake wire
harness. use cable tie to secure
the air hose along the way. the
outlet of the air hose should be
located at the positive battery
terminal side. Install the air filter
assembly to the air hose and tie it
with a cable tie as shown in Figure
18.
ImPOrtaNt: If the vehicle
is equipped with a catalytic
converter, it should be inspected.
Diesel catalysts may become
plugged with soot and can cause
a restriction to exhaust flow,
impeding performance. shine a
powerful flashlight into the inlet
end of the converter. Observe
the light through the other end of the converter. the full circle
of the flashlight should be
visible without any blockage in
the gridwork of the catalyst. If
excessive soot is observed, the
catalyst may need to be cleaned.
takE PrECautIONs to
avoid blowing soot toward the
Figure 19
Figure 20