Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Exhaust Brake '03-early 04 - Manual (Page 15)

9 7 0 5 3 v 8 . 0
| 15
switch bezel on the driver’s side
by gently pulling on it. Disconnect
the electrical connector once the
bezel is removed.
38.
To remove the center bezel,
open the ashtray and cup holder
and remove the retaining screw.
Gently pull on the center bezel to
disengage all the clips that attach
the bezel to the dash. Disconnect
four (4) the electrical connections
after the bezel is removed.
39.
Remove the cluster bezel
by first removing the top two
(2) screws. Gently pull on it and
disengage all the clips that attach
the bezel to the dash.
40.
Cut out the supplied template
(see Figure A on page 23) and
align the template onto the front
of the cluster bezel by placing its
left edge against the cluster rib,
and its bottom edge against the
cluster bottom edge. use masking
tape to securely hold down the
template.
NOtE: Do not tape over the
markings on the template.
41.
using a 1 ⁄
2
” uni-drill, center
the bit onto the 1 ⁄
2
” drill location
on the template and slowly drill
through the IP. remove and
discard the template and any
plastic shavings.
NOtE: It is important that the
hole is drilled at the recommended
location. the switch may not clear
the instrument panel structure
if the hole is shifted to another
location.
42.
remove the two (2) ribs on
the back of the cluster next to the
1 ⁄
2
” hole. test fit the brake switch
through the hole to ensure that
the ribs do not interfere with the
switch installation. remove all the
necessary material on the cluster
to fit the switch properly,
43.
align the Banks Brake label
onto the previously drilled hole.
make sure the entire mounting
surface is clean and free of dirt
and oil before mounting the label.
Clean and dry as required using
a cloth dampened with rubbing
alcohol or similar cleaning
solution.
CautION: Do not spray fluid
directly onto any electrical
equipment, or equipment damage
may result.
mount the Banks Brake switch
label onto the cluster by peeling
off the protective backing off
the adhesive tape on the back
of the switch label. hold the
label against the panel for
approximately 20 seconds while
applying pressure to allow the
adhesive to properly adhere to the
surface.
44.
attach power switch wires
(rED, yELLOW, BLaCk) to
power switch as shown in Figure
13.
45.
Remove the chrome bezel
nut from the power switch shaft.
Insert the switch shaft into the
hole that was drilled in the dash
panel. Install the provided switch
plate cover and reinstall the
chrome bezel nut.
46.
Find the 14-pin connector
on Banks Brake wire harness,
and plug it into the supplied
Computerized Brake Controller
Figure 17
Figure 16