Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Exhaust Brake '03-early 04 - Manual (Page 9)

9 7 0 5 3 v 8 . 0
| 9
rather than the wires themselves.
10.
From inside the vehicle,
continue to pull the harness
through the firewall until 18” of
the wire harness comes through.
NOtE: the Banks Brake wire
harness installations are different
with different vehicle years and
transmission types. refer to
TABLE 1 at bottom of page 7
for the specific instruction on
your particular model year and
transmission type. see Wire
Connection reference on page 23
for more details.
For 2003 Vehicles
with automatic
transmissions
11.
Locate the WhItE wire with
OraNGE stripe in the wire loom
entering the large black electrical
connector on the driver side. this
is the same connector removed
in step 4. Install a t-tap on this
WhItE wire with OraNGE
stripe. Plug the Banks Brake
OraNGE wire into this t-tap.
see Figure 4.
12.
Locate the solid rED wire in
the same wire loom that enters the
large black electrical connector.
Install a t-tap on the rED wire.
Plug the Banks Brake BLaCk
wire that is in the same convolute
as the OraNGE wire into this
t-tap.
13.
use the nylon ties to tie
the two (2) BrOWN Banks
Brake wires to the BLaCk and
GrEEN wire pair convolute (the
BrOWN wires are not applicable
Figure 5
Figure 4
table 1: Installation Procedures for Different
model year and transmission type
No. model year transmission type steps
1 2003 automatic 11 to 16
2 2003 manual 17 to 22
3 2004 automatic 23 to 28
4 2004 manual 29 to 34