Warning, Air compressor panel and wire harness installation – Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Exhaust Brake '03-early 04 User Manual
Page 5
9 7 0 5 3 v 8 . 0
| 5
WarNING!
For trucks with automatic
transmissions, it is highly
recommended that the Banks
Brake be used with the Banks
smartLock for optimal braking
performance
DO NOt install the Banks
smartLock if either one of the
following applies:
1) the PCm is not located on the
passenger side firewall behind
the battery.
2) the engine is a high-output
(325-hp rated) engines.
1.
as a precaution, disconnect the
ground of the battery (if there is
more than one battery, disconnect
both grounds).
2.
raise the front of the vehicle
and support it with properly
weight rated safety stands, ramps
or a commercial hoist. Follow the
manufacturer’s safety precautions.
take care to support the vehicle to
prevent it from slipping or falling.
When using ramps, be sure the
front wheels are centered squarely
on the topsides; place transmission
in park; set the parking brake
and place blocks behind the rear
wheels.
3.
remove the front tire on the
driver side. remove the front
wheelhouse splash shield on the
driver side by removing eight (8)
screws (8mm head). Detach the
aBs wire that is clipped on the
splash shield before completely
removing the shield to avoid
damage to the wire.
4.
For 2003 vehicles only: Locate
the large black electrical connector
on the driver’s side between the
battery and the firewall. see
Figure 1. remove the two (2)
air Compressor Panel and Wire harness Installation
Figure 1
Figure 2