Grain Systems PNEG-1798 - Manual (Page 13)

PNEG-1798 Tower and T-Series Dryers Vaporizer 13
7. Procedure
7.1. Dryer Data Information (from its GSI Data Plate)
7.1.1. Record the model # of the dryer on the TD-VIP-01 data sheet. (Hereafter referred to as the
data sheet.)
7.1.2. Record the serial # of the dryer on the data sheet.
7.1.3. Record the panel voltage required on the data sheet.
7.1.4. Record the panel current (amperage) on the data sheet.
7.1.5. Record the customer’s name on the data sheet.
7.1.6. Record the dryer location on the data sheet.
7.1.7. Record the name of the company performing the vaporizer installation.
7.2. Vaporizer Hardware Verification
NOTE: To perform the installation process in an efficient manner the hardware and piping that is
necessary should be verified as being available and on site prior to starting the installation. Any
items that were not located must be reported to the GSI project management group as soon as
possible to schedule delivery.
Refer to vaporizer train drawing that is attached as appendix ‘A’ in this procedure for hardware
items and their position in the train.
7.2.1. Verify that there are (3 ea.) 21' lengths of 1-1/4" SCH 80 black iron pipe. (Record this on the
data sheet.)
7.2.2. Verify that there are (3 ea.) 21' lengths of 3/4" SCH 80 black iron pipe. (Record this on the
data sheet.)
7.2.3. Verify that there is actually a vaporizer coil assembly pre-mounted or positioned unsecured above
the burner of the dryer. (See Figure 7A.) (Record this on the data sheet.)
Figure 7A Vaporizer Coil