Assembly (continued), Installation, Instructions – Grain Systems Tanks PNEG-4030 User Manual
Page 73
Advertising
![background image](/manuals/277603/73/background.png)
8. Instructions
PNEG-4030 40 Series 27' and 30' Diameter Bins
73
Assembly (Continued)
Figure 8B
Installation
8. If the roof sheet does not have a pre-punched hole for the roof vent, a hole must be cut. The cut hole
should match the roof vent. The hole’s inside edge should be approximately 15" from the eave.
9. Place the three (3) foam strips on roof sheet, as shown in
. Position roof
vent over foam strips and bolt down using 5/16" x 3/4" bin bolts and nuts. NOTE:
for lower two (2) bolts of vent.
Figure 8C
Ref #
Part #
Description
A
MIS-4404
Hold-Down Angle
B
Short Side Approximately 15-3/8"
C
Long Side Approximately 15-7/8"
Advertising