Angle, Assembly (continued), Installation – Grain Systems Tanks PNEG-4030 User Manual
Page 76: Instructions
Advertising
8. Instructions
76
PNEG-4030 40 Series 27' and 30' Diameter Bins
Assembly (Continued)
Figure 8G
Installation
7. If the roof sheet does not have a pre-punched hole for the roof vent, a hole must be cut. Cut the hole
to match the roof vent. The inside edge of the hole should be approximately 15" from the eave.
8. Place the three (3) foam strips on roof sheet, as shown in
. Position roof
vent over foam strips and bolt down using 5/16" x 3/4" bin bolts and nuts. NOTE:
for lower two (2) bolts of vent.
Figure 8H
Ref #
Part #
Description
A
MIS-4404
Hold-Down Angle
B
Short Side Approximately 15-3/8"
C
Caulk with Tube Caulking
(Three (3) sides of vent housing.)
D
Long Side Approximately 15-7/8"
Advertising