66 inside stiffened, Extension rails, Eave adjustable braces – Grain Systems Bin Accessories PNEG-1096 User Manual

Page 13

Advertising
background image

13

PNEG-1096 Ladder, Safety Cage, & Platforms

2.66 INSIDE STIFFENED

Note: Reference previous page for the

first ladder standoff starting location.

REF. NO.

DESCRIPTION

PART NO.

1

END TUBE

LS-6616

2

CENTER TUBE

LS-6615

3

SAFETY CAGE BRACKET

LS-4349

4

SAFETY CAGE EXT. RAIL

LS-4355

5

LADDER SECTION

LDR-4002

6

OUTSIDE STANDOFF

LS-121

REV. 9/11/01

EXTENSION RAILS

Extension rails are provided to extend the side rails of the ladder above the eave of the
roof and to support the safety cage at that point. Two rails have been provided, one for each
side of the ladder. Refer to diagram above for proper location and assembly of the extension
rails in relation to the ladder. Use 5/16" x 3/4" bolts and nuts to attach the ladder. Tighten the
bolts at this time.

EAVE ADJUSTABLE BRACES

After extension rails are firmly attached, the adjustable braces must be attached at this

time. A larger diameter tube and two smaller diameter tubes are used to make up one
adjustable brace. Slip the smaller tubes inside the larger tube and attach one smaller tube to
the top of the extension rail. Adjust the other smaller tube so the bottom of the flattened tube
reaches the roof rib. Field drill four 5/16" holes through both large and small adjustable tubes
and bolt together using 1/4" x 1.1/2" bolts and nuts. This will keep the adjustable brace from
slipping.

Attach the safety cage brackets to the extension rail and ladder as shown in the

diagram. Brackets must be placed every 44". This will occur at every ladder joint. Use 5/16" x
3/4" bolts and nuts.

6

1

2

3

4

5

FIELD DRILL 5/16'' HOLES
(4) PER BRACE

LS-6696

Advertising