Grain Systems Bin Accessories PNEG-1096 - Manual (Page 74)

74 PNEG-1096 Ladder, Safety Cage, & Platforms
2.66 (OPTIONAL)
LADDER
SECTION
LDR-4002
LADDER PLACEMENT
Ladder placement on the grain bin is very important at this time. Refer to the diagrams above and
follow the correct dimensions as shown. Ladder extension must be located 8" below the horizon-
tal seam. Check your ladder to make sure the ladder rung dimples are to the top surface. Attach
extension bracket (LS-6676) to sidewall. Extension bracket brace and ladder standoff will attach
to upper hole in extension bracket, refer to diagrams for orientation. Attach ladder to the standoffs
using the holes located 6 1/4" from the end of ladder section. Use 5/16" x 3/4" bin bolts for these
connections. Now all extension brackets must be located in horizontal seam holes (repeating
every 32") until reaching the first rest platform. Extension bracket braces (LS-6704) attach at
every other horizontal seam. Refer to the section in these instructions that references the location
of intermediate rest platforms for further hole locations.
LADDER
EXTENSION BRACKET
LS-6676
OUTSIDE
STAND-OFF
LS-121
LADDER EXTENSION
BRACKET BRACE
LS-6704
REV. 10/9/01