Grain Systems Bin Accessories PNEG-914 - Manual (Page 15)

PNEG-914 Flex-Flo 15
5. Installation
Boot and Transfer Plate Installation
NOTE: Installation of the boot is the same whether the tank has the standard collar or the Sure-Flo Feed
Flow Control.
Slide the boot as far as possible into the tank collar or the Sure-Flo Feed Flow Control opening.
(See Figure 5A.) Align the boot with the Flex-Flo System that will be installed. Using the holes in the collars
for guides, drill eight (8) 11/32" holes into the boot rim. (See Figure 5B.)
Mount the boot to the collar with the hardware provided. Bolt the transfer plate and unloader braces to the
boot as shown.
See Figure 5C for proper usage and assembly direction of hardware for mounting the boot
and the transfer plate. All connections should be tightened until they are “snug”.
Figure 5A Figure 5B
Figure 5C
Improper installation methods of the hardware may cause permanent damage and
possible breakage of the boot.
CAUTION