Kwik-attach drop kit installation, Drop kit installation (continued) – Grain Systems Bin Accessories PNEG-914 User Manual
Page 24
5. Installation
24
PNEG-914 Flex-Flo
Drop Kit Installation (Continued)
7. Thread the short rope end through the red ball and tie a knot in the rope to hold the ball in place.
Install the green ball the same way on the other rope end.
8. Apply a small amount of PVC cement around the drop to prevent it from moving around on the
auger tube.
9. Two (2) screws are supplied for attaching an optional drop tube.
Use both screws to attach the drop tube securely to the drop kit.
Kwik-Attach Drop Kit Installation
Figure 5O Drop Kit Installation
1. Snap the slide around the tube over the outlet hole.
2. Fasten the housing to the tube using two (2) hose clamps. Make sure the outlet hole is in the middle
of the housing.
3. Slide can be rotated from side to side to open and close the drop kit.