Installation – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1375 User Manual
Page 22
Advertising
![background image](/manuals/277728/22/background.png)
22
PNEG-1375 Farm/Commercial Distributor Cable Control
5. INSTALLATION
Calibrating the Distributor Spout and the Lower Cable Control Wheel
1. Place the discharge spout index trigger to the far right as shown in
.
2. Using the Index Number Decal (Decal part number DC-1799), peel off one of the numbers
(numbered 1 through 10) and place on the Spout Decal Plate in front of the Spout Position
Arrow
.
3. Move to the next spout by pulling up on the Control Handle to disengage the Index Trigger
while rotating the Lower Cable Control Wheel counter-clockwise.
4. Repeat
until all spouts have been labeled on the Spout Decal Plate.
Figure 5O
Advertising