Grain Systems PNEG-583 - Manual (Page 11)

11
SEREIS ONE HEATER
1. Mark location on transition one
(1) foot up from the bottom
(entrance collar) and centered
in the transition.
2. Drill or knock out 7/8" diameter
hole on marked location.
3. Install transition hi-limit using
supplied self drilling screws.
TRANSITION HI-LIMIT INSTALLATION
Figure 3: The transition connecting the heater to the bin with the plenum
thermostat in place.
PLENUM THERMOSTAT
MOUNTING
The plenum thermostat is the 4 x 4 white box with knob
that is preconnected to heater when heater is ordered
with thermostat.
1. 24" to the right side of the transition, drill one 3 /
8
" hole
(high temp) or 1 1 /
2
" hole (low temp) in the center of
the plenum in a valley (4.00" corrugation) or hill (2.66"
corrugation) on bin sidewall.
2. Insert the probe through the hole.
3. Position the housing so that the tabs are vertical, and
the cord exits the housing horizontally.
Plenum thermostat mounting on bin wall.
5. Caulk between the housing and the sidewall to seal.
4. Use 4 self drilling screws to mount the housing to the bin
sidewall.
HEATER INSTALLATION