Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 30)

12" & 16" Series II Sweep Special PNEG-1579
Assembly
D. Slide the twelve tooth drive sprocket, bushing and key (see the key chart for your key size) onto the
output shaft of the reducer, making sure both sprockets line up. (See Fig TD3 & TD4)
9. GUARD ASSEMBLY - (CONT.)
Wedging forces in the bushing saw slot, such as that exerted by a narrow
edged regular screw driver, may damage or break the bushing. This damage
would not be covered under the GSI Warranty
1 HP - 5/16" x 2" Key
2 HP - 3/8" x 3-3/4" Key
3 HP - 3/8" x 3" Key
KEY CHART
FIG. TD3
Assemble 12 Tooth Sprocket,
Bushing and key to Gear Reducer
Output Shaft
FIG. TD4
To Assemble the Inner Lower Shaft
Seal, this Sprocket and Bushing
May Have to be Loosened and
Moved Out of the Way
29-A